Roads View history

Introduction

This section is being developed.

== DO NOT TRANSLATE THIS PAGE TO ANY OTHER LANGUAGE. INSTEAD MAKE A COPY IF NEEDED AND ADD TO YOUR OWN LANGUAGE/AREA ON ITS OWN PAGE. ==


See the following forum posts for discussion:

Abbreviations

The following abbreviations should be used where possible to conserve screen space.

Road Name Abbreviation TTS Expansion?
Avenue Ave Yes
Boulevard Blvd Yes
Broadway Bdwy Untested
Close Cl Yes
Court Ct Untested
Crescent Cr Yes
Drive Dr Yes
Garden Gdn Untested
Gardens Gdns Yes
Green Gn Untested
Grove Gr Untested
Lane Ln Yes
Mount Mt Untested
Place Pl Yes
Park Pk Untested
Road Rd Yes
Square Sq Untested
Street St Yes
Terrace Ter Untested

Notes:

  1. Roads like "The Avenue", "The Green" etc should not normally be abbreviated.
  2. TTS = Text To Speech for future Waze version support in UK.

Road types

The following convention should be followed where possible, although it is acknowledged that you may need to deviate from it in some circumstances.

Waze Road Type UK Road Types
Freeway Motorway
Major Highway Trunk roads (other than motorways) as defined below.
Minor Highway Non-trunk A-class roads or dual-carriageway B-class
Primary Street Other B-class roads and roads carrying heavier traffic, often seen on Ordnance survey maps in yellow or orange.
Streets Urban Streets, Low traffic rural roads

Scottish Trunk Roads (Traffic Scotland)

English Trunk Roads (Highways Agency) | London Trunk Roads (Transport for London)

N Wales | Mid Wales | S Wales (Traffig Cymru)

Combined Map

Dual Carriageways

The following convention should be followed where possible, although it is acknowledged that you may need to deviate from it in some circumstances.

Under Development

Motorway Carriageway Naming Convention

Whenever possible, on split roads, name carriageways with the direction of travel. Insert the direction of travel at the end of the road name:

Examples:
1. M1 (N)
2. A4 (W)
3. M25 (ACW)

This makes traffic and incident reports much more useful and helps with navigation.

Ramps (to/from Motorways and Dual Carriageways)

For the best balance between information, routing, reports and screen real estate the following convention should be used for the ramp road type:


Exit Ramps:

<Road Number> (<Direction>) (<Junction Number>) “Exit” (<” to ” Road Number 1, Road 2 …>

Examples:
1. M54 (E) J4 Exit to A464
2. A46 (N) Exit to A6
3. M1 (S) J24 Exit to A453, A6
4. M1 (N) J24 Exit to A453


Entry Ramps:

“Entry to” <Road Number> (<Direction>) (<Junction Number>)

Examples:  
1. Entry to M54 (E) J4
2. Entry to A46 (N)
3. Entry to M1 (S) J24
4. Entry to M1 (N) J24


Notes:

  1. Fields marked in parenthesis (<field>) are optional.
  2. Onward roads should only added if they are shown on road signage as this is an aide to the driver to confirm they have the correct exit. (Hint: look on streetview).
  3. There’s no need to put a direction the onward road number as this would only be possible if there’s no choice (e.g. M1 (S) J23A to A42) and then there’s no point.

Junction Naming

When naming/numbering junctions, particularly on motorways, please ensure the landmark is kept tight to the road system to ensure a tidy transfer to the client. The "snap-to" feature when adding landmarks via Papyrus should make this process easier!

or...


Large, freehand rectangles should be avoided...

Road Name & Number

Where a road exhibits both a road number and name the following convention should be used:

<Number> - <Name>

Examples:
1. A7 - Old Dalkeith Rd
2. A1 - Edinburgh Rd

This gives both a consistent appearance and allows a straightforward transfer if/when Waze UK moves to the official Department for Transport designations.

The same can also be said for adding the direction of travel on single/dual carriageways with an A-road designation in the form

<Number> (Direction) - <Name>

Examples:
1. A2 (W) - Dover Rd
2. A229 (N) - Cuxton Rd

Roundabouts

To aid navigation instructions, roundabouts should typically remain unnamed - where the client comes across a segment with no name it will use the next named segment as the next named instruction whilst retaining any turn signals.

Bypass or By-pass?

Bypass.