(*/Special_roads/Main*/) |
Poncewattle (talk | contribs) (Redoing section, it was a bit of a mess. Lifted formatting from New York) |
||
Line 2: | Line 2: | ||
------ DO NOT MODIFY ABOVE THIS LINE -------- DO NOT MODIFY ABOVE THIS LINE ------> | ------ DO NOT MODIFY ABOVE THIS LINE -------- DO NOT MODIFY ABOVE THIS LINE ------> | ||
===== State specific special road guidelines ===== | |||
The following special roads are managed slightly uniquely in some states and territories. | |||
======Parking Lot Roads====== | |||
{{RootPage2}} uses the following national standard guidelines found in the Wiki for [[Road_types/USA#Parking_Lot_Road|Parking Lot Roads]]. | |||
======Alleys====== | |||
{{RootPage2}} uses the following guidelines for mapping alleys. | |||
*Alleys should always be mapped if they have a name. | *Alleys should always be mapped if they have a name. | ||
*Alleys should always be mapped if they are the sole access to a home or business. | *Alleys should always be mapped if they are the sole access to a home or business. | ||
*Alleys should always be set to "Private" | *Alleys should always be set to "Private" | ||
*Alleys are normally mapped if they are acknowledged by the municipality. | *Alleys are normally mapped if they are acknowledged by the municipality. | ||
If an alley does not meet the above criteria, mapping is optional. Leave the name field blank. | If an alley does not meet the above criteria, mapping is optional. Leave the name field blank. | ||
=== Non-drivable roads === | Be careful adding alleys which will be closer to the destination pins for house numbers, or from Google, as this can cause all navigation to all the addresses on that block to route onto the alley instead. It may be better not to map these alleys, or you may have to adjust all the address pins to be closer to the actual roads. | ||
====== Dirt roads ====== | |||
This state uses the following national standard guidelines found in the Wiki for [[Road_types/USA#Dirt|Dirt Roads]]. | |||
====== Non-drivable roads ====== | |||
Generally, if a path can't be driven on (e.g. Walking Trail, Pedestrian Boardwalk, Stairway, Runway/Taxiway) then it not normally mapped, unless approved by a Virginia State Manager or the Mid-Atlantic Regional Coordinator. If it is mapped, it should not be connected to any roads, its elevation should be set to 9 and it should be locked at Level 5. This is due to the way the routing engine works, as Waze '''will''' route users to drive on these "Non-Drivable" road types. | Generally, if a path can't be driven on (e.g. Walking Trail, Pedestrian Boardwalk, Stairway, Runway/Taxiway) then it not normally mapped, unless approved by a Virginia State Manager or the Mid-Atlantic Regional Coordinator. If it is mapped, it should not be connected to any roads, its elevation should be set to 9 and it should be locked at Level 5. This is due to the way the routing engine works, as Waze '''will''' route users to drive on these "Non-Drivable" road types. | ||
Revision as of 20:53, 9 December 2014
State specific special road guidelines
The following special roads are managed slightly uniquely in some states and territories.
Parking Lot Roads
Virginia uses the following national standard guidelines found in the Wiki for Parking Lot Roads.
Alleys
Virginia uses the following guidelines for mapping alleys.
- Alleys should always be mapped if they have a name.
- Alleys should always be mapped if they are the sole access to a home or business.
- Alleys should always be set to "Private"
- Alleys are normally mapped if they are acknowledged by the municipality.
If an alley does not meet the above criteria, mapping is optional. Leave the name field blank.
Be careful adding alleys which will be closer to the destination pins for house numbers, or from Google, as this can cause all navigation to all the addresses on that block to route onto the alley instead. It may be better not to map these alleys, or you may have to adjust all the address pins to be closer to the actual roads.
Dirt roads
This state uses the following national standard guidelines found in the Wiki for Dirt Roads.
Non-drivable roads
Generally, if a path can't be driven on (e.g. Walking Trail, Pedestrian Boardwalk, Stairway, Runway/Taxiway) then it not normally mapped, unless approved by a Virginia State Manager or the Mid-Atlantic Regional Coordinator. If it is mapped, it should not be connected to any roads, its elevation should be set to 9 and it should be locked at Level 5. This is due to the way the routing engine works, as Waze will route users to drive on these "Non-Drivable" road types.
The "Railroad" road type serves two purposes in Waze. First, it provides drivers with visual orientation relative to railroad and light-rail tracks. More importantly, in the common case where passenger-carrying tracks lie parallel with roads, mapping the tracks allows Waze to recognize spurious speed data from people Wazing on the train and prevent it from corrupting speed data for the adjacent road. Please see USA Road Types wiki page for more information on mapping railroads.