Rest areas: Difference between revisions Discussion View history

(entrance ramp name and place area categories updated)
m (→‎Exiting the highway: corrected inaccurate statement about red roads.)
Line 26: Line 26:
If the main entrance is a two-way road, just use a parking lot type.
If the main entrance is a two-way road, just use a parking lot type.


As with all newly created roads, be sure to [[Creating_and_Editing_street_segments#Confirm_the_road_by_updating_details|confirm the roads]] so they appear on the client map.
As with all newly created roads, be sure to [[Creating_and_Editing_street_segments#Confirm_the_road_by_updating_details|confirm the roads]] so they route properly on the client map.


'''Naming'''
'''Naming'''
Line 53: Line 53:
|Truck Haven || to Truck Haven
|Truck Haven || to Truck Haven
|}
|}


=== The main parking area ===
=== The main parking area ===

Revision as of 04:12, 3 November 2014

This article is a US-based set of guidelines. It includes the community recommended guidelines for mapping rest areas.

Definitions

In Waze, the following terms are defined as follows:

Rest Area

A convenient stopping place located directly off of a highway, which typically provides, at minimum, parking and restroom facilities. Some may have information kiosks, vending machines, picnic areas or "dump" facilities for RVs.

Welcome Center or Visitor Center

A special type of rest area, often located near state borders or near major airports.

Service Area or Service Plaza

In some states may also include private commercial businesses such as fuel stations, and restaurants. These rest areas are typically found along the East Coast.

Other related terms

A rest area or Rest Stop with limited or no public facility is a Parking Area, Scenic Area, Wayside Park, Roadside Park, or Picnic Area. These also have navigational value, and provide drivers a safe place to pull off the highway to rest, or do other tasks. These should be included as a rest area when editing the map (with special guidelines below).

Mapping guidelines

Exiting the highway

Road type

In general follow the standard guidelines for road types leaving the highway as can be seen along the highway nearby the rest area.

If the exit from the highway is a one-way road that can be taken at speed, it should be a ramp.

If the main entrance is a two-way road, just use a parking lot type.

As with all newly created roads, be sure to confirm the roads so they route properly on the client map.

Naming

Follow the guidelines for your area when naming the exits from the highway. In the US follow these guidelines. For example a typical exit ramp would be named "Exit ##: Rest Area" (if numbered), or simply "to Rest Area" if not numbered. If the Rest Area has a unique name or additional information, posted on signs at or approaching the area, common to plazas, and welcome centers, that should be included in the ramp name.

Basically Entrance ramps should be named matching their signs, according the Road Names wiki guidance.

A few examples
Sign Says Ramp Name
Rest Area => to Rest Area
Parking Area => to Parking Area
Rest Area
Louisiana Welcome Center
to Rest Area / Louisiana Welcome Center
Rest Area
Tourist Information Center
to Rest Area / Tourist Information Center
Exit 34
Beckley Travel Plaza
Exit 34: Beckley Travel Plaza
Rest Area
Trucks Only
to Rest Area / Trucks Only
Truck Haven to Truck Haven

The main parking area

Road type

Inside the parking area there should be at least one segment using the parking lot road type that links between the exit from and return to the highway. Follow the general guidelines for mapping a parking lot meaning only the main roads of the rest area should be mapped.

Using only the parking lot road type will prevent the Waze server from sending cars off and on the highway through the rest area to avoid traffic.

Naming

Generally the parking lot roads are not named, but if inside the city limits be sure to include the city name.

Returning to the highway

Road type

When selecting the road type, generally follow the same guidelines as was done for the exit from the highway unless it is significantly different from the exit and would not make sense to match the exit type.

Naming

Also follow the standard convention as was used for the exit. For interstates the typical convention would be "to I-5 N" (to Highway_Name Cardinal) and if a control city is shown on the local signs use "to I-5 N / Sacramento". If other information is displayed on the signs at the entrance back to the highway, add those to the name as appropriate according to the guidelines.

Adding a Place

The Rest Area Place area should be covered by an Area Place, drawn to the borders, and along right-of-way of the adjacent highway, but not snapped to the highway. Use two separate Places if there are two separate rest areas which are not connected by driveable roads on opposite sides of a single highway.

Place categories

  • Transportation (with no subcategory selected) should be set as the primary category.
This will facilitate search results for Wazers who search for transportation related results. It is logically the best match category for these venues.
  • Scenic Outlook / Viewpoint (under Outdoors) should be set as the second category.
This category result is triggered anytime a Wazer searches for the words Rest stop, or Rest area, therefore to ensure the rest areas will appear in the search results for these search terms, this category needs to be included.
  • Any other appropriate categories for the venue based on other services available there, i.e. ATM, Food, Shopping, etc., except for Gas station. Gas stations should be mapped as a separate place area following the Gas station place guidance, and mapped to the boundaries of the gas station area.


Place naming

Except for Welcome Centers, name the Place using the highway name, cardinal direction, and mile marker in the following format: [highway] [direction] mile [mile] [Rest Area type]. For example,

I-59 N mile 152 Rest Area – for a rest area on northbound I-59 at mile marker 152.
I-59 S mile 11 Parking Area – for a parking area (no services) on southbound I-59 at mile marker 11.
I-10 mile 122 Rest Area – for a rest area on I-10 at mile marker 122 which is accessible from both sides of a highway.
I-75 S mile 15 Scenic View - for a scenic overlook (signed "scenic view") on southbound I-75 at mile marker 15

For named service plazas and travel plazas (which typically offer fueling stations, restaurants, etc.), you may use the common name:

I-77 mile 45 Beckley Travel Plaza – for the Beckley Travel Plaza, a large service plaza on the WV Turnpike
New Jersey Tpke N mile 5 John Fenwick Service Area – for the John Fenwick Service Area on the northbound NJ Turnpike

Also, if fuel is offered, add a Gas Station Place over that location in the service plaza.

Do not use a given name for a standard rest area, however, as those names are not typically known to the general driving public. You may put a name given to a rest area by the state DOT in the "description" field of the Place.

For Welcome Centers, name the Place using the highway name, cardinal direction, and state name in the following format: [highway] [direction] [state] Welcome Center / Rest Area. For example:

I-65 S Alabama Welcome Center / Rest Area for the Ala. welcome center on southbound I-65
I-81 N Virginia Welcome Center / Rest Area for the Va. welcome center on northbound I-81

This way, welcome centers should also be found when searching "Rest Area", since they typically have the same services.