|
|
| (43 tussenliggende versies door 2 gebruikers niet weergegeven) |
| Regel 1: |
Regel 1: |
| When traffic moves between two roads that are at the same grade, these connecting segments are not technically ramps to Waze (unless it falls into one of the [[#Exceptions|Exceptions]] listed below). How to handle these connectors depends on the exact situation.
| | {{TopLine}} |
| | <languages /><translate> |
|
| |
|
| == Should the connector be mapped? == | | ==Area Manager== <!--T:1--> |
| | [[File:Badge AreaManager.png|top|right]] |
|
| |
|
| First and foremost, the need to have the connector mapped needs to be established. As the driver approaches an intersection, Waze has usually given at least one warning that a turn is imminent, and we can assume that the driver is already looking for turn lanes. For most intersections, that is enough to guide the driver into the proper lane and to turn at the proper time; in other words, it is enough that the two roads intersect without separately mapped turning lanes.
| | <!--T:2--> |
| | * Wanneer je een <i>Area Manager</i> (AM) wilt worden, moet je een actieve deelnemer zijn aan de Waze [[Community|gemeenschap]] en graag een actieve en pro-actieve rol spelen bij het onderhouden van het gewenste [[Editable area|gebied]] op de Waze kaart. |
| | * Om Area Manager te worden moet je een [[Community_Levels#Waze_Level_Upgrade_Form|aanvraag]] indienen.<br /> |
| | * Wanneer je [[Editor level|editor level]] nog geen '''3''' is, krijg je dit level direct of snel na jouw AM gebied. |
|
| |
|
| There are only a few situations in which connectors are called for in an intersection:
| | === Taken === <!--T:3--> |
| *when the turn lane physically separates from the main road well in advance of the intersection; | | * Het monitoren van jouw [[Editable area|gebied]] op wegwerkzaamheden. |
| *when the turn lane is far enough from the point of intersection on the map (due to the size of the intersection or the angle at which the roads meet) that the driver might overshoot while waiting for a delayed "turn" audible, or that the Waze client might become confused and disrupt navigation | | * Het plaatsen van [[Closures|afsluitingen]] op tijdelijk afgesloten wegen. |
| *when the area is "busy" enough that the driver may not get any advance warning that a turn is coming up--in which case a connector lets you notify the driver a little earlier | | * Het wegennet bijwerken door het toevoegen, wijzigen en verwijderen van wegen. |
| *As an [[Area Manager]], when you get a user complaint that the audible was too late, or that the map should have shown a connector | | * [[User request|UR's]] verwerken. |
| | * [[Map Problems|kaart fouten en problemen]] verwerken en oplossen. |
| | * Snelheids- en roodlicht [[Camera|cameras]] onderhouden, [[Speed limit|maximum snelheid]] gegevens up-to-date houden, en alle andere aanpassingen die nodig zijn om de kaart in jouw gebied zo [[KISS|bruikbaar]] mogelijk te maken. |
| | * Optreden als een mentor voor andere editors, advies geven. |
| | * Actie ondernemen wanneer je foutieve danwel ongelukkige edits op de kaart tegenkomt. |
| | * En actief zijn in de Nederlandse Waze [[Community|gemeenschap]] door het participeren in [[Slack]] en op het [[Forum|forum]]. |
| | <br /> |
| | Voor het complete Nederlandse Waze carrière pad: zie de [[Community Levels|Gemeenschaps levels]] pagina. |
| | </translate> |
|
| |
|
| When in doubt, leave it out. Each connector complicates the map and adds to your workload when the time comes to check connectivity, direction, name, etc.
| | {{Bottomline}} |
| | |
| == How to label the connector type ==
| |
| | |
| Although sometimes referred to as ramps, to Waze these are '''not''' ramps. Ramps in Waze should only be used for situations where two roadways have a grade separated intersection or if the situation matches one of the [[#Exceptions|Exceptions]] listed below.
| |
| | |
| The connector segment's type should be set based on the '''lowest''' of the types of roads it connects.
| |
| | |
| *Ex: Street to Minor Highway should be Street type.
| |
| *Ex: Minor Highway to Primary Street should be Primary Street type.
| |
| *Ex: Primary Street to Primary Street should be Primary Street type.
| |
| | |
| Example:
| |
| | |
| [[Image:At-grade_example1.jpg]]
| |
| | |
| Also note how the top-left quadrant of the intersection does not have a connector mapped because it does not meet the requirement of being significantly separated from the main intersection.
| |
| | |
| == How to name the connector ==
| |
| | |
| In most cases, leaving the segment unnamed will be sufficient. Navigation instructions will simply use the name of the segment to which the connector segment connects.
| |
| | |
| If there are specific signs at the intersection which are confusing or contrary to the destination road segment name, then a name can be applied to the connector.
| |
| | |
| == Geometry of the connector ==
| |
| | |
| The [[Junction Style Guide]] provides significant information on how to best set the geometry of the connector to get the best routing and text-to-speech result. Be sure to review that article when updating or creating these connectors.
| |
| | |
| == Turn restrictions necessary for proper connector routing ==
| |
| | |
| Connectors, if simply added to the map and all turns allowed, would cause significant routing challenges, especially between two 2-way roads. Split roadways have their own challenges, but turn restrictions, due to the 1-way nature of the main segments, are simpler.
| |
| | |
| In the US, a simple right-turn connector between two 2-way streets, requires that the right turn at the primary intersection be restricted:
| |
| | |
| [[Image:Atgrade example3.jpg]]
| |
| | |
| | |
| AND, at the end of the connector, the left turn must be restricted:
| |
| | |
| [[Image:Atgrade example2.jpg]]
| |
| | |
| | |
| If you enable the "show all restricted connectivity arrows" function in the editor at this intersection, you can see there are many restricted turns. This is sometimes a target for someone looking to remove all restricted turns by abusing the use of the 'w' or Allow All Connections function:
| |
| | |
| [[Image:Atgrade example4.jpg]]
| |
| | |
| | |
| == Exceptions ==
| |
| | |
| === Connector is a signed, numbered exit ===
| |
| '''Example:''' Garden State Parkway Exit 10 in Cape May Court House, New Jersey, USA. The Garden State Parkway is mostly a freeway class toll-road that runs north/south through New Jersey. As the Parkway approaches its southern terminus, the number of lanes reduce and exits become a mix of grade separated ramps and at-grade intersections.
| |
| | |
| Going north, the right turn lane is signed as Exit 10B and the left turn lane is signed as Exit 10A (and reversed going south).
| |
| | |
| [[Image:GSP_10A.jpg]][[Image:GSP_10B.jpg]]
| |
| | |
| [[Image:GSP_10.jpg]]
| |
