Diferencia entre revisiones de «Translations:Controlling U turns/35/es Ver historial

m (Created Redirect)
 
(Importando una nueva versión desde fuente externa)
 
Línea 1: Línea 1:
#REDIRECT [[Best_map_editing_practice#When_.28Not.29_to_Split_a_Two-Way_Road]]
* To allow median U-turns in both directions, break condition #2 by making the median segment (B) {{:Routing_penalties/U-turn_minimum|greater}} ''or longer''
* To allow a U-turn from only one direction, first set up U-turn prevention for both directions. Break condition #3 on the side where U-turns are allowed. Increase or decrease the angles so that the in and out segments (A and C) are [[#Checking for parallel incoming and outgoing segments|not parallel]]. A [[Glossary#mDL|micro-dogleg]] can be used to change the angle without changing the appearance of the segment.

Revisión actual - 01:49 1 may 2017

Información acerca del mensaje (contribuir)
Este mensaje no tiene documentación. Si sabes dónde o cómo se usa este mensaje, puedes ayudar a los otros traductores añadiendo documentación a este mensaje.
Definición del mensaje (Controlling U turns)
* To allow median U-turns in both directions, break condition #2 by making the median segment (B) {{:Routing_penalties/U-turn_minimum|greater}} ''or longer''
* To allow a U-turn from only one direction, first set up U-turn prevention for both directions. Break condition #3 on the side where U-turns are allowed. Increase or decrease the angles so that the in and out segments (A and C) are [[#Checking for parallel incoming and outgoing segments|not parallel]]. A [[Glossary#mDL|micro-dogleg]] can be used to change the angle without changing the appearance of the segment.
  • To allow median U-turns in both directions, break condition #2 by making the median segment (B) Routing penalties/U-turn minimum or longer
  • To allow a U-turn from only one direction, first set up U-turn prevention for both directions. Break condition #3 on the side where U-turns are allowed. Increase or decrease the angles so that the in and out segments (A and C) are not parallel. A micro-dogleg can be used to change the angle without changing the appearance of the segment.