User:T0cableguy/CDPs View history

Use of the City Field in Florida

Use the following checklist step-by-step to determine whether the "City" field for a segment or place should contain a name or be marked as "None":

STEP 1 - Incorporated Municipality. Is it on the list of legally incorporated municipalities? If NO, proceed to Step 2. If YES, check if your segment / place falls within the city limits by using Florida Mapping Resources. If it is not within the city limits, make sure it's not in an adjacent city or eligible location specified below. If not, stop here, you're done.

STEP 2 - Large Census Designated Place. Is it on the list of large Census Designated Places? If NO, then proceed to Step 3. If YES, The geographic boundaries of many CDP's can be found on the US Census Bureau website; use these boundaries. See if the county PA / GIS website listed at Florida Mapping Resources shows the boundaries. If you still can't find defined boundaries for the CDP, take a scroll through along a major roadway in street view to see where FDOT or the county may have placed signs indicating where the CDP begins and ends.

STEP 3 - County Property Appraiser. If you look up a parcel on the roadway in question using a Property Appraiser's website listed at Florida Mapping Resources, does it list your target name as a valid address? If NO, proceed to Step 4. If YES, try to determine the boundaries for use of that City name by checking subsequent parcels in the area or checking county GIS sites listed at Florida Mapping Resources.

STEP 4 - Indian Reservations / Government Installations. Is the segment / place located on an Indian Reservation or Government Installation? If NO, proceed to Step 5. If YES, listing the name of the reservation or installation in the City field may be appropriate. If you think YES, consult a State Manager or Regional Coordinator for more guidance.

STEP 5 - Other Place of Significance. There are many other Census Designated Places and points of interest throughout Florida, but many are small. Does your target location have a major cultural significance (e.g. tourist attraction, county seat, travel milestone (e.g. Yeehaw Junction))? If you think YES, consult a State Manager or Regional Coordinator for more guidance. If NO, then mark the City field as "None". Stop here, you're done. There are no more options.

NEWPAGE

This new page is currently undergoing modifications. The information and guidance is currently considered accurate enough to be followed now. Content is being prepared by one or more users. Do not make any changes before you send a private message to this user.

This is a clickable interactive guide to determine when a city name should or should not be used in the city field of a segment or place.

A text version of this information is available here.

Introduction

While the illustrations displayed by each question may not represent every possible variation, they do represent the difference between the two options in that question. Please choose the most appropriate answer.

Notes

NOTE: Mailing addresses alone are not a determining factor for filling in the City field; city limits are. For example, everyone who lives in Leon County has a "Tallahassee, FL" mailing address, but not everyone in Leon County lives within the incorporated city limits of Tallahassee. Most unincorporated county areas should have the City field checked as "None", unless they meet one of the following exceptions.

Directions

To use this interactive flowchart;

Start with the first question in The Interactive Algorithm.
Click on the appropriate answer which best matches your situation. A new question will jump to the top of the screen
Continue answering the questions until an instruction is displayed at the top of the screen.

The interactive algorithm

(01)

Other than the origin and the destination, are there any other segments connected to this junction?

YES

NO => No Instruction

(19)

Do the origin and the destination meet at a Roundabout?

YES

NO

(02)

Is the turn angle from the origin to the destination between How Waze determines turn / keep / exit maneuvers/Turn threshold and 150°?

YES

[[#04\|NO, the turn angle is less How Waze determines turn / keep / exit maneuvers/Stay threshold]]

NO, the turn angle is greater than 150°

SPECULATION NOTE: This is unconfirmed Turns with angles greater than 150° will follow the same instruction path as [[#03|How Waze determines turn / keep / exit maneuvers/Turn threshold-150°]], but the Waze routing server will penalize this turn, and avoid routing through it.

(03)

Which direction is the turn?

Left => Turn Left

Right => Turn Right

(04)

Are there any other branches with unrestricted turns from the origin?

YES

NO => No Instruction

(13)

Is there more than one (1) other branch?

YES

NO

(14)

Are the two branches (the destination and the other branch) overlapping?

YES => No Instruction

NO

(05)

Is the name of the origin and the destination identical?

YES

NO

(06)

Are the origin and the destination the same road type?

YES

NO

(07)

Are both the name AND the road type of any of the other branches identical to the origin?

YES

NO => No Instruction

(08)

Is there any other branch to the left of the destination branch?

YES

NO

(20)

Is this an overlapping segment, is it overlapped by any other branch?

YES

NO

(25)

Are the segments in a right hand traffic country (such as the USA)?

YES

NO => Keep/Stay Right

(21)

Is the origin a highway? ( Freeway , Major Highway , or Minor Highway )

YES

NO

(22)

Is the destination a highway? ( Freeway , Major Highway , or Minor Highway )

YES => Keep/Stay Left

NO => Exit Left

(23)

Is the origin a Ramp ?

YES

NO => Keep/Stay Left

(24)

Is the destination a highway ( Freeway , Major Highway , or Minor Highway ), or a Ramp ?

YES => Keep/Stay Left

NO => Exit Left

(09)

Is the name of any of the other branches identical to the origin?

YES

NO => No Instruction

(10)

Are the origin and the destination the same road type?

YES

NO

(11)

Is the name of any of the other branches identical to the origin?

YES

NO

(12)

Is the road type of any of the other branches identical to the origin?

YES

NO => No Instruction

(26)

Are the segments in a left hand traffic country (like the UK)?

YES

NO => Keep/Stay Left

(15)

Is the origin a highway? ( Freeway , Major Highway , or Minor Highway )

YES

NO

(16)

Is the destination a highway? ( Freeway , Major Highway , or Minor Highway )

YES => Keep/Stay Right

NO => Exit Right

(17)

Is the origin a Ramp ?

YES

NO => Keep/Stay Right

(18)

Is the destination a highway ( Freeway , Major Highway , or Minor Highway ), or a Ramp ?

YES => Keep/Stay Right

NO => Exit Right

(27)

Are there five (5) or more segments (junctions) connected to the roundabout?

YES => At the Roundabout Take the #xx Exit

NO

(28)

From the perspective of the origin, are the roundabout angles to all the other segments between 0°-15°, or 75°-105°?

YES

NO => At the Roundabout Take the #xx Exit

(29)

What direction is the destination relative to the origin?

Left => At the Roundabout Turn Left

Straight => At the Roundabout Continue Straight

Right => At the Roundabout Turn Right

U Turn, Back => At the Roundabout Make a U Turn

The navigation instructions

No Instruction

There will be No instruction given passing through this junction. This can be caused by several factors including

Best Continuation
Certain cases with an overlapping segment
The instruction would be Continue Straight (this doesn't yet exist in the client application)

Displayed Icons
Livemap & WME	Client App
	Not Available in Client App

Turn Right

Displayed Icons
Livemap & WME	Client App

Keep/Stay Right

Displayed Icons
Livemap & WME	Client App

Exit Right

Displayed Icons
Livemap & WME	Client App

NOTE:

In a left hand traffic country this instruction does not exist, and will instead give a Keep/Stay_Right instruction.

You will only get an Exit instruction on a turn angle less than How Waze determines turn / keep / exit maneuvers/Stay threshold, because it is assumed no true exit would have a turn sharper than How Waze determines turn / keep / exit maneuvers/Stay threshold.

Turn Left

Displayed Icons
Livemap & WME	Client App

Keep/Stay Left

Displayed Icons
Livemap & WME	Client App

Exit Left

Displayed Icons
Livemap & WME	Client App

NOTE:

In a right hand traffic country this instruction does not exist, and will instead give a Keep/Stay_Left instruction.

You will only get an Exit instruction on a turn angle less than How Waze determines turn / keep / exit maneuvers/Stay threshold, because it is assumed no true exit would have a turn sharper than How Waze determines turn / keep / exit maneuvers/Stay threshold.

At the Roundabout Take the #xx Exit

The "#xx" will be 1st, 2nd, 3rd, etc.. The counting starts from the origin.

Displayed Icons
Livemap & WME	Client App

NOTE: In the client app there will be a digit inside the circle representing which number exit you must take (starting from the origin).

If the roundabout is not formed correctly (more than one entering/exiting segment connected to same roundabout node), you may get an instruction "at the roundabout, exit number 0" with a partial verbal instruction.